SERVICES

Warm air, weak airflow and short cycling all trace back to a small list of causes. We test refrigerant charge, capacitors, contactors, coils and airflow in order, find the actual fault, and repair it the same visit whenever parts allow.

• Same-day diagnostics
• Repairs on every major brand
  

New cooling equipment gets selected from a load calculation, not from the nameplate on the old unit. We size, install and commission systems that meet the 14.3 SEER2 Southeast minimum, then verify performance before we hand it over.

• Manual J load calculation
• Labor warranty included
  

A spring tune-up catches the weak capacitor, dirty coil and plugged drain line before the first 95 degree week finds them for you. We clean, test, measure and document, then tell you exactly what we saw.

• Coil cleaning and drain clearing
• Written system report
  

A furnace that runs without heating usually points to a flame sensor, limit switch, blocked condensate line or gas pressure problem. We diagnose with combustion analyzers and manometers, not guesswork, and we check the heat exchanger every time.

• Combustion and safety testing
• Gas and electric heat covered
  

Replacing a furnace is the right call when repairs stack up or efficiency has slipped. We calculate the real heating load, match equipment to it, handle venting and permits, and leave the system balanced and tested.

• Code-compliant venting
• High-efficiency options
  

Fall service is the difference between a furnace that starts on the first cold morning and one that does not. Our tune-up covers burners, ignition, gas pressure, safeties, airflow and carbon monoxide readings.

• Carbon monoxide testing
• Heat exchanger inspection
  

Burning smells, tripping breakers, sudden no-heat calls and total cooling loss do not wait for business hours. We answer around the clock, stabilize the situation safely, and get the system running again as fast as parts allow.

• Around-the-clock availability
• Safety-first troubleshooting
  

Bonus rooms, additions, sunrooms and converted garages rarely behave on the main duct system. A ductless mini-split gives that space its own thermostat, its own capacity and its own quiet inverter compressor.

• Single and multi-zone systems
• Mitsubishi equipment installed
  

Indoor air often carries several times the pollutant load of the air outside. We match filtration to what your blower can actually move, then address humidity, ventilation and the dust paths your ductwork creates.

• MERV matched to your system
• Humidity and ventilation review
  

Most smart thermostat trouble is a wiring problem, not a device problem. We confirm C wire availability, verify staging compatibility with your equipment, install cleanly and set the schedule up before we leave.

• C wire and staging verified
• Setup and app walkthrough
  

Buying a house, settling an insurance question or just wondering what you own, an inspection answers it. We measure temperature split, check airflow, review ductwork and give you a written condition report.

• Pre-purchase inspections
• Written condition report
  

Rooftop units, split systems and zoned equipment keep businesses open. We build maintenance schedules around your season, service economizers and controls, and handle repairs before a comfort complaint becomes a closed door.

• Rooftop unit specialists
• Scheduled maintenance plans